Icom Decoding
Instead I ordered the Band decoder Mk2 by remoteqth.com. It’s a universal design based on an Arduino and comes as a kit complete with an SMT pre-soldered PCB, a few through-hole parts, I2C display as well as a professionally looking enclosure. It can be configured for various data sources, be it Icom’s Ci-V, Icom band voltage, Yaesu. This video demonstrates what is needed to use the Icom IC-R8600 to listen to DMR transmissions.Software and Drivers are needed. Links are below:USB I/Q Pack.
Floridasand
Member
Icom Serial Number Decoding
Ior Decoder
- Joined
- Dec 19, 2007
- Messages
- 27
- Location
- Diamond Bar, CA
Icom 7300 Decoding Cw
Hi Everyone,
I did not see anything posted for my questions. I have a ICOM IC-R8600 receiver. I love this receiver however I have a problem that I need to figure out. I can see the waveform for a particular Phase 1 unencrypted signal with a good strong signal strength, but it will not decode or allow me to listen to the frequency. I also have the ICOM IC-R30 receiver and it decodes the NAC and channel information 100 percent of the time. I can listen to all unencrypted transmissions. Are there any special settings that I need to use to hear and decode the phase 1 signals??? The waveform shows it great. Signal strength is from -76 to -84 Dbm. I have switched antennas and tested both receivers with the different antennas. I am receiving in the 771 MHz band. I can post a Youtube video that shows exactly what is happening. I have the current firmware and like I said the R30 never missed one transmission. Thanks for any help or information.
Floridasand
I did not see anything posted for my questions. I have a ICOM IC-R8600 receiver. I love this receiver however I have a problem that I need to figure out. I can see the waveform for a particular Phase 1 unencrypted signal with a good strong signal strength, but it will not decode or allow me to listen to the frequency. I also have the ICOM IC-R30 receiver and it decodes the NAC and channel information 100 percent of the time. I can listen to all unencrypted transmissions. Are there any special settings that I need to use to hear and decode the phase 1 signals??? The waveform shows it great. Signal strength is from -76 to -84 Dbm. I have switched antennas and tested both receivers with the different antennas. I am receiving in the 771 MHz band. I can post a Youtube video that shows exactly what is happening. I have the current firmware and like I said the R30 never missed one transmission. Thanks for any help or information.
Floridasand